ONLY ANT+™ DEVICES: Your device is ANT+™ certified and fully compatible with ANT+™ instruments: heart rate monitors (to measure heart beats), cadence sensors (to measure the pedal stroke frequency) and speed sensors (to measure speed values).
|
Product ANT+™ certified, it complies with the following specified ANT+™ device profiles. |
|
Full list of ANT+™-compatible products: http://www.ThisisANT.com |
Once the sensors are in place, follow these steps to start paring information:
1. Select ‘Activate HR/Cad/Spe’.
2. Then, the device will start looking for the sensor signal.
3. If available, it will be displayed (data will be stored for each point of the recorded track).
NOTE: Use water, ECG gel or other conductive liquids to moisten the conductive rubber contact, do not use vaseline or oils, they may insulate the transmitter making it unable to detect the heart rate signals. Do not bend or stretch the transmitter and keep it out of extreme cold and heat. Clean and dry the transmitter carefully after use, do not store wet.