ONLY ANDROID DEVICES: If your device is compatible with BLE technology (Bluetooth Low Energy), then you will be able to use sensors such as: heart rate monitors (to measure heart beats), cadence sensors (to measure the pedal stroke frequency) and speed sensors (to measure speed values).
Once the sensors are in place, follow these steps to start paring information:
1. Select ‘Connect & Scan’.
2. Then, the device will start looking for the sensor’s signal.
3. If available, it will be displayed (data will be stored for each point of the recorded track).
NOTE: Use water, ECG gel or other conductive liquids to moisten the conductive rubber contact, do not use vaseline or oils, they may insulate the transmitter making it unable to detect the heart rate signals. Do not bend or stretch the transmitter and keep it out of extreme cold and heat. Clean and dry the transmitter carefully after use, do not store wet.