When navigating a route, you can select a required event to validate a waypoint and switch to the following one:
•Radius of the next waypoint: Enter inside the radius of the next waypoint (only that one).
•Radius of any next waypoint: Enter inside the radius of any of the next waypoints (next one and any of the succeeding waypoints).
•e-Roadbook mode: When entering the radius of any waypoint, it will be set as next. When going out of it, next one will be activated. When following an e-roadbook it is required to show the information of the current waypoint while in its surroundings. This way, instructions for each point can be followed correctly.
•Bisector inside next waypoint: Enter inside the radius of next waypoint and cross the bisector that is formed with the previous and next waypoint.
•Bisector inside next waypoint or 10% of any waypoint: Same as the previous, but if any waypoint is quite near (10% of its radius) it will be validated and the next one will be activated.
•Only buttons bar: Never change to next waypoint automatically, only manually when 'Next waypoint' or 'Previous waypoint' buttons are pressed.
A default radius can be assigned for route waypoints, this value will be taken when this information is not available. If radius for a concrete waypoint of the route is defined, it will be respected. But in case that waypoint does not have a specific radius, the default one will be used instead.