ONLY ANT+™ DEVICES: If your device is compatible with ANT+™ technology (ANT+ Alliance), then you will be able to use sensors such as:
•Heart rate monitors: To measure heart beats
•Cadence sensors: To measure the pedal stroke frequency
•Speed sensors: To measure speed values
|
|
Product ANT+™ certified, it complies with the following specified ANT+™ device profiles. |
|
|
Full list of ANT+™-compatible products: http://www.ThisisANT.com |
Follow these steps to start paring information:
1. Put the sensors in place, ANT+™ sensors need to be activated before attempting to connect to them.
2. Once done, at TwoNav select ‘Activate’.
3. Then, the device will start looking for the sensor’s signal.
4. If available, it will be displayed (data will be stored for each point of the recorded track).
NOTE: Use water, ECG gel or other conductive liquids to moisten the conductive rubber contact, do not use vaseline or oils, they may insulate the transmitter making it unable to detect the heart rate signals. Do not bend or stretch the transmitter and keep it out of extreme cold and heat. Clean and dry the transmitter carefully after use, do not store wet.
